After you try to Repair connections using the repair wizard, Network Magic displays a set of instructions that is customized to the connectivity problem detected.

Here is an example from the repair wizard:

Make sure your networking cables are connected. For each cable connecting your networking equipment ...

After you follow the steps and try to fix the problem, use the wizard to test the repair. If the repair is successful, you can continue networking normally. If there is still a problem, you can go to the next instructions link and try to fix the problem.

1. In the Summary page of the repair wizard, click the first link.
   
   Network Magic opens this Help file and displays the repair steps.

 

2. Complete the steps.

 

3. Return to the Summary page of the repair wizard, and click Test Again.
   
   Wait briefly. Network Magic analyzes your network connections.

 

4. On the Summary page, check the results.
   
   If the problem was repaired, Network Magic displays a check mark and a message that the repair was successful.
   
   If there is still a problem, Network Magic displays a message that the repair was not successful. On the Summary page, you should click the next instructions link, and then repeat steps 2 through 4 of this procedure. Continue to do so until you fix the problem or have completed all the custom instructions. 

 

If you are unable to fix the problem, see If there is still a problem.